which tablesaw are you considering???..
take the DC to at least 1100 CFM… you won’t regret it…
take a look at JessEm tables… the cat’s meow +1st rate quality… their CS is next level…
I built my own 60" cabinet and used JessEm’s top and lift… big money saver…
bigger drawers = less material and work than multiple small drawers…
easier to set up the DC too…
all the ply you see is splined smaller panels…
see Dust Collection #2 - #4 by HerbStoops
the left of the table is open for adding rollers when working larger material. the miter knife and to accept Leigh’s D4 and FMT…
all working surfaces and table tops are on the same plane…
after a while this is one of the tools to go…
I use a Plan “B” w/ better results and far less waste…
and get a track saw as a bonus…
DIY TRACK SAW+JOINER.pdf (101.6 KB)
also…
I made a couple of these to take the place of the joiner…
these are used on the TS and you can do tapers w/ them also…